Attaching The Front Door To The Chassis - Cisco Nexus 7702 Hardware Installation Manual

Attaching the Front Door to the Chassis

d) Place the top and bottom hood frame as shown in the figure. Secure the hood frames with four M3 screws.
Step 2
Attach the side filter to the cable management assembly as follows:
a) Remove 4 M3 screws as shown in the figure.
Figure 10: Attaching the Top Hood to the Chassis and Cable Management Assemblies
1
2
b) Attach the side filter assembly to the cable management assembly.
c) Use the 4 M3 screws to secure the side filter to the cable management assembly.
d) Repeat Steps 2a through 2c to attach the side filter assembly on the other side of the cable management assembly.
What to Do Next
You are ready to attach the optional door to the cable management frames.
Attaching the Front Door to the Chassis
Before installing the front door to the chassis, you must install an air filter to the front door.
Cisco Nexus 7702 Hardware Installation Guide
26
Side filter assembly
Four M3 screws to secure the side filter to the cable management assembly.
Installing the Switch Chassis