Installing Or Replacing A Power Supply In A Switch Chassis - Cisco Nexus 7706 Hardware Installation Manual

Installing or Replacing Modules, Fan Trays, and Power Supplies
Two alignment pins on the top and two alignment pins on the bottom should align to holes at the top and bottom of
the fan tray slot.
Figure 31: Installing a Fan Tray
1 Hold both handles with both of your hands.
b) With the electrical contacts on the fan tray aligned to contacts on the back plane, press the fan tray fully into the slot.
The front of the fan tray should be even with the fronts of the other fan trays and the four captive screws on the fan
tray should be aligned to four screw holes in the chassis.
c) Screw in each of the four captive screws on the front of the fan tray to secure the fan tray to the chassis. Tighten each
screw to 8 in-lb (0.9 N·m) of torque.
d) Verify that the Status LED is green. For more information about the LED states, see

Installing or Replacing a Power Supply in a Switch Chassis

You can install up to power supplies of the following types:
OL-31330-01
Installing or Replacing a Power Supply in a Switch Chassis
2 Position the alignment pins at the top and bottom
of the fan tray to alignment holes in the chassis and
press the fan tray into the slot.
I/O Module LEDs, on page
Cisco Nexus 7706 Hardware Installation Guide
118.
89