Connecting To The Network; Guidelines For Connecting Ports - Cisco Nexus 7706 Hardware Installation Manual

Connecting to the Network

This chapter contains the following sections:
•
•
•
•
•

Guidelines for Connecting Ports

You can use CPAK, Quad Small Form-Factor Pluggable Plus (QSFP+), Small Form-Factor Pluggable Plus
(SFP+), and Small Form-Factor Pluggable (SFP) transceivers to connect the ports on the I/O modules to other
network devices, which can include other switches or Fabric Extenders (FEXs). The SFP+ transceivers include
Fabric Extender Transceivers (FETs) for connecting I/O modules with FEXs.
The transceivers used with copper cables come already assembled with their cables. The transceivers used
with fiber-optic cables come separated from their cables. To prevent damage to the fiber-optic cables and
their transceivers, we recommend that you keep the transceivers disconnected from their fiber-optic cables
when installing the transceiver in the I/O module. Before removing a transceiver for a fiber-optic cable, remove
the cable from the transceiver.
To maximize the effectiveness and life of your transceivers and optical cables, do the following:
• Wear an ESD-preventative wrist strap that is connected to an earth ground whenever handling transceivers.
• Do not remove and insert a transceiver more often than is necessary. Repeated removals and insertions
• Keep the transceivers and fiber-optic cables clean and dust free to maintain high signal accuracy and to
OL-31330-01
Guidelines for Connecting Ports, page 41
Connecting a Console to the Switch, page 42
Connecting the Management Interface, page 43
Creating the Initial Switch Configuration, page 44
Connecting Interface Ports to the Network, page 45
The switch is typically grounded during installation and provides an ESD port to which you can connect
your wrist strap.
can shorten its useful life.
prevent damage to the connectors. Attenuation (loss of light) is increased by contamination and should
be kept below 0.35 dB.
◦ Clean these parts before installation to prevent dust from scratching the fiber-optic cable ends.
4
C H A P T E R
Cisco Nexus 7706 Hardware Installation Guide
41