Position Sensor On The Magnet - OHAUS PA64 Service Manual

3.3.33 Installing the Load Cell PCB-Temperature Sensor-Position Sensor Assembly
5. Place the Position Sensor on the Magnet. It has a cavity allowing it to rest squarely,
aligned with the screw holes. (See Figure 3-157.) The Ratio Beam pin must be
centered in the hole in the back. (See Figure 3-158.)
Figure 3-157. Position Sensor on the Magnet.
6. Install the Ratio Beam Ribbon Cable on the PCB and the Contact Board.
Pioneer™ Balance Service Manual
CHAPTER 3 MAINTENANCE PROCEDURES
Ratio Beam
Pin centered
in PSB hole
Cavity
under PSB
clears Ratio
Beam Vane
Figure 3-158. Pin centered in PSB.
53
3- Ohaus Corporation www.ohaus.com