CHAPTER 3 MAINTENANCE PROCEDURES
3.3.27 Removing the Block Style Load Cell from the Base Plate
This procedure is necessary before proceeding with other repairs to the Load Cell.
Base Plate Removal
Remove the Weigh Below Hook and Screw. (See Figure 3-109.)
1.
2. Hold the Block Style Load Cell and remove the two Load Cell Mounting Screws.
(See Figure 3-109.)
Note: At this point, other repairs may be made to the Load Cell.
Ohaus Corporation www.ohaus.com
Mounting Screws
Figure 3-109. Base Plate Removal.
3-40
Weigh Below Hook & Screw
Pioneer™ Balances Service Manual