Installing The Block Style Load Cell On The Base Plate - OHAUS PA64 Service Manual

3.3.28 Installing the Block Style Load Cell on the Base Plate

Mating
Surfaces
Mounting
Screws
Base Plate Installation
1. Make sure the mating surfaces on the Base plate and the Load Cell are clean.
(See Figure 3-110.)
2. Position the Load Cell on the base and install the two mounting screws.
Do not tighten them fully.
3. Looking down at the top of the Load Cell, align it with the Base Plate.
(See Figure 3-111.)
Now carefully tighten the two mounting screws and re-check alignment.
4.
5. Install the Weigh Below Hook and screw at the bottom of the Base Plate.
(See Figure 3-110.)
Pioneer™ Balance Service Manual
Figure 3-110. Load Cell Mounting Components.
Figure 3-111. Load Cell Alignment to Base Plate.
3-
CHAPTER 3 MAINTENANCE PROCEDURES
Block Style
Load Cell
Weigh Below Hook & Screw
Alignment Area
41
Ohaus Corporation www.ohaus.com
Base Plate