CHAPTER 3 MAINTENANCE PROCEDURES
3.3.31 Removing the Ratio Beam on Block Style Load Cells
Note: Not all Load Cells require a Weight Arm as shown. If the Load Cell does not
have this style Weight Arm, proceed to Step 9.
Remove the screws, washers and nuts holding the InCal Weight Arm.
6.
(See Figure 3-126.)
Loosen Nut
Figure 3-126. Loosening InCal Weight Arm
Carefully slide the InCal Weight Arm as shown in Figure 3-128.
7.
Figure 3-129 illustrates the InCal Weight Arm removed.
Ohaus Corporation www.ohaus.com
InCal Weight Arm
Hold Stationary
nuts.
Figure 3-128. InCal Weight Arm Removal.
Figure 3-129. InCal Weight Arm removed.
Figure 3-127. Weight Arm Screws
and Washers removed.
InCal Weight Arm
InCal Weight Arm
3-46
Pioneer™ Balances Service Manual