Aluminum Sleeves Removed - OHAUS PA64 Service Manual

3.3.31 Removing the Ratio Beam on Block Style Load Cells
Remove the aluminum sleeves. (See Figure 3-130.)
8.
Note the position of the Up/Down
9.
Stop Screw. Turn the Up/Down Stop
Screw so the Ratio Beam can be
removed. (See Figure 3-131.)
Figure 3-131. Up/Down Stop Screw.
10. Remove the centering pins.
(See Figure 3-132.)
Carefully lift out the Ratio Beam. (See Figures 3-135 and 3-136.)
11.
Figure 3-135. Removing the Ratio Beam.
Remove the Aluminum Sleeves.
12.
(See Figure 3-137.)
This completes the disassembly.
Pioneer™ Balance Service Manual
CHAPTER 3 MAINTENANCE PROCEDURES
Aluminum Sleeves
Figure 3-130. Aluminum Sleeves removed.
Figure 3-132. Centering Pins removed.
Figure 3-136. Ratio Beam Removed.
Figure 3-137. Removing the Aluminum
47
3- Ohaus Corporation www.ohaus.com
Aluminum Sleeves
Centering Pins
Sleeves.