6. Remove the Power Module, it is fitted with two nuts (see fig. below).
Assembly
Assemble in the reverse
1. Fit the Power Module with the two nuts (see fig. above).
2. Connect the electrical connections to the Power Module. Note their positions (see fig. on previous page).
3. Fit the Power Module bracket with its lower section partly inside the rear edge of the chassis. Secure
the electronics with the lock handles on the left and right hand side of the chassis making sure the
tabs are reengaged (see fig. on previous page).
4. Fit the chassis covers. See page 8-9.
5. Switch the main fuse to ON. See page 50.
The Power Module is fitted with two nuts.
order.¨
47
Power Module