Permobil M300 Service Manual page 15

Batteries
7. On Permobil M300, the batteries are secured
with battery locks. Remove these by pushing
them downwards/towards the center of the
chassis (see fig.).
8. Disconnect the battery connections (see fig.).
See also the sticker on the inside of the front
chassis cover.
9. Lift/pull the battery out of the chassis using the
battery belt.
m WARNING!
Observe care in the use of metallic objects when working
with batteries. A short-circuit can easily cause an explosion.
Always use protective gloves and protective eye-glasses.
The batteries are heavy and must be handled with care.
Used or broken drive batteries should be taken care of in an
environmentally correct manner in accordance with locally
applicable recycling directions.
10. Lift a new battery into the chassis using the
battery belt. Leave the battery belt on the
battery. Position the battery with the battery
terminals at the front.
11. Refit the battery connections to the new
battery (see fig.). See also the sticker on the
inside of the front chassis cover.
12. On Permobil M300, refit the battery locks by
pushing them downwards and at the same
time into the intended recess in the chassis
(see fig. above).
13. Fit the cover partially inside the chassis at the
lower edge, then secure it with the two knobs.
(see fig.).
On Permobil M300, the batteries are
secured with battery locks.
Front battery connections.
Fit the cover partially inside the
chassis at the lower edge.
15
Batteries