Resetting The Main Fuse; Fuses - Permobil M300 Service Manual

Fuses

Fuses

Resetting the main fuse

The main fuse also functions as a battery isolator
but it is usually called the main fuse.
It is not normally necessary to replace the main
fuse as it is automatic and can be reset when it has
been triggered. The main fuse can be accessed
through a recess in the rear chassis cover. It is
reset by switching the switch to ON (see fig.).
m CAUTION!
If the main fuse is triggered, there is often a major electrical
fault. The cause of the fault should be checked carefully
before the fuse is reset.
Removal
1. Remove the chassis covers. See page 8-9.
2. Switch the main fuse to OFF (see fig. above).
3. Detach the negative cable from the rear battery.
4. Detach the positive cable from the front battery.
5. Remove the main fuse, which is held in place
with two nuts (see fig. below).
On chassis with VR2 Control System the
Main Fuse is fitted with two nuts.
6. Disconnect the cables from the mail fuse by loosening the screws (see fig.).
m CAUTION!
Note the direction in which the fuse is installed for subsequent
fitting. The ON/OFF position must match the appropriate
sticker on the chassis.
Off
Main fuse/battery isolator (On/Off).
For this task the following tools are necessary:
1 Wrench 6 mm.
1 Phillips head screwdriver
m CAUTION!
Fold the battery connection cables under so they cannot come
into contact with the battery terminals.
On chassis with R-net Control System the
Main Fuse is fitted with two nuts.
Main fuse cable connection.
50
On