Permobil M300 Service Manual page 10

Covers
Covers
Removing the front link arm covers.
Both sides of the link arms have covers fitted. The
covers are fitted with four screws.
1. Switch off the main power switch on the control
panel.
2. Remove the drive wheel on the side in question
(see page 18).
3. Remove the four screws holding the covers
(see fig.).
Assembly
Assemble in the reverse order.
1. Fit the covers using the four screws (see fig.).
2. Fit the drive wheel on the side in question (see
page 18).
For this task the following tools are necessary:
1 Torx key TX20.
Front link arm covers.
Front link arm covers.
10