Control Panel Vr - Permobil M300 Service Manual

Control panel VR2

Removal
1. Remove the upper and rear chassis cover.
See page 8.
2. Loosen the control panel cabling from its
fixing points. Remember how the cabling
is positioned; this helps when you come to
re-attach it.
3. Disconnect the control panel cabling from the
Power Module (see illustration).
4. Remove the control panel (4). It is held in place
with two screws underneath (see illustration).
Assembly
Assemble in the reverse order.
1. Fit the control panel (4) with the two screws (see fig.).
2. Connect the control panel cabling to the Power Module (see illustration).
3. Re-attach the cabling to its fixing points.
4. Refit the upper and rear chassis cover. See page 8
4
The control panel is held in place with two screws.
For this task the following tools are necessary:
1 Allen key 4 mm.
The control panel cabling is connected
to the Power Module.
43
Control Panel