eka KF 1010 EV UD Use And Instruction Manual page 24

Hide thumbs

page of 28

/ 28
Bookmarks

_ TECNOEKA Srl __________________________________________________________ use and instruction manual _

5.3 Changing the door seal

5.3

Changing the door seal

5.3

Changing the door seal

The door seal has a rigid profile with fixing tabs. The profile must be fitted into the guide on

the face of the cooking chamber.

To change the seal, remove the old one from the guide by pulling hard at the four corners.

Clean any dirt from the guide and introduce the new seal (to make this operation easier, we

advise dampening the seal profile with soapy water).

5 5 5 5 .4 .4 .4 .4 Possible faults

Possible faults

Type of fault

Control panel completely off

(the oven does not work)

Cooking cycle set and START

push button pressed: the

oven does not work

Door closed: steam comes

out of the seal

The oven does not cook

evenly

Lighting lamp in the cooking

chamber does not work

_ page 24 _________________________________________________________________________________________

Cause

- Incorrect electric connections to the mains

- No mains voltage

- Thermal break safety device tripped

- Electronic card protection fuse (power)

burnt

- Door open or ajar

- Damaged magnetic sensor

- Seal not fitted correctly

- Damaged seal

- Handle prong loosened

- One of the motors is blocked or turns

slowly

- The motors do not go into reverse

- Heating

element

not

damaged

- Damaged lamp

- Damaged lamp feeder

- Check the mains connection

- Restore mains voltage

- Reset the thermal break safety device