Advertisement
_ Electronic Ovens _ rev. 1 _____________________________________________________________ KF 1010 EV UD
3.2.20 Start clock push button
3.2.20
Start clock push button
3.2.20
3.2.20
Start clock push button
Start clock push button
With the oven turned ON or during the cooking cycle, when the push button
any time, the current time can be checked on the time display (the other displays are
deactivated).
3.2.21 Programmed ignition
3.2.21
Programmed ignition
3.2.21
3.2.21
Programmed ignition
Programmed ignition
With the oven turned OFF, when the push button
have been entered for programmed ignition: the time (time display), the day (temperature
display) and the cooking program number (program display). To change the parameters press
the push button
the knob no. "1" to enter the required ignition hour. The figures showing the day start flashing
on the temperature display: use knob no. "2" to enter the required day (from 1 = Monday to 7
= Sunday). The two figures relative to the cooking program start flashing on the program
display: use the scroll buttons to enter the required cooking program number. Press the push
button
again and the two figures showing the minutes start flashing on the time display: use
the knob no. "1" to enter the required minutes. Press the push button
is shown on the time display. Press
is on stand-by ready for programmed ignition.
To cancel programmed ignition press the push button
3.3 Magnetic door sensor
3.3
3.3
3.3
Magnetic door sensor
Magnetic door sensor
Magnetic door sensor
This device stops the oven and the cooking cycle each time the door is opened.
3.4 First ignition
3.4
First ignition
3.4
3.4
First ignition
First ignition
The oven can be used for the first time only after the chamber has been carefully cleaned
with a special detergent for stainless steel. The detergent must not contain acid substances
(chloride acid, bleach, etc.) or be abrasive. Alternatively the chamber can be washed with warm
soapy water or warm water and a drop of vinegar. Rinse well and dry with a soft cloth.
First ignition (without food inside the oven) serves to eliminate any unpleasant smells (which
are quite normal) due to the thermal insulation heating up that covers the cooking chamber and
any oil residues from assembly of the metal parts.
After turning the power on (close the unipolar switch fitted upstream from the appliance)
and the water (open the cut-off cock), proceed as follows (see the figure of the control panel):
-
press the on/off push button;
-
set the time (knob "1") at one hour (shown on the time display);
-
set a temperature (knob "2") of 270°C for the cooking chamber (shown on the
temperature display);
-
check the door is closed;
-
press the start/stop push button: the cooking chamber starts heating up.
When the time is up, the oven turns off automatically and the beeper sounds for 10 seconds.
3.5 Cooking techniques
3.5
Cooking techniques
3.5
3.5
Cooking techniques
Cooking techniques
There are three different cooking techniques with this oven which can be used singularly,
one after the other or combined.
_________________________________________________________________________________________ page 17 _
. The two figures showing the hour begin flashing on the time display: use
and the green led starts flashing to confirm that the oven
is pressed, the parameters are shown that
again.
is pressed at
and the current time
Advertisement
