Scanner Self-Test - Panasonic KV-S3065CL SERIES Service Manual

9.4.

Scanner Self-test

Without connecting scanner to PC, the following contents can be done as the scanner self-test.
The following test is mainly available for mechanical test after replacing or reassembling rollers (Drive Roller, Conveyor Roller) and
other mechanical parts related to feed documents.
*7
Note:
Regarding each LED's (Front, Back) position in the following figure, see Sec.3.
Test Item
1. Paper Feed Motor's 1. While pushing "STOP/START key" on the front
rotating cover, turn on the scanner.
2. Release the key at the timing when the front LED
status changes from blinking to ON.
3. Push the "STOP/START key" once to enter into the
test selection mode.
4. Push the "STOP/START key" once at the timing
when the back panel LED's status is 1 (h)
Note:
This operation allows the scanner to select the
Feed Motor's rotating test.
5. Push the "STOP/START key" once to start the test. Green
6. Push the "STOP/START key" once to stop the test. Green
7. Turn off the scanner to finish the test.
2. Conveyor Motor's 1. While pushing "STOP/START key" on the front
rotating cover, turn on the scanner.
2. Release the key at the timing when the front LED
status changes from blinking to ON.
3. Push the "STOP/START key" once to enter into the
test selection mode.
4. Push the "STOP/START key" once at the timing
when the back panel LED's status is 2 (h)
Note:
This operation allows the scanner to select the
Conveyor Motor's rotating test.
5. Push the "STOP/START key" once to start the test. Green
6. Push the "STOP/START key" once to stop the test. Green
7. Turn off the scanner to finish the test.
3. Hopper Drive 1. While pushing "STOP/START key" on the front
cover, turn on the scanner.
2. Release the key at the timing when the front LED
status changes from blinking to ON.
3. Push the "STOP/START key" once to enter into the
test selection mode.
4. Push the "STOP/START key" once at the timing
when the back panel LED's status is 4 (h)
Note:
This operation allows the scanner to select the
Hopper Drive test.
5. Push the "STOP/START key" once to start the test. Green
6. Push the "STOP/START key" once to stop the test. Green
7. Turn off the scanner to finish the test.
Operation
*1
.
*2
.
*4
.
93
LED status
*7 *7
Front Back
- -
Orange (Blinking) OFF→Blinking
→Green
Green Blinking→Count
Green
- -
- -
Orange (Blinking) OFF→Blinking
→Green
Green Blinking→Count
Green
- -
- -
Orange (Blinking) OFF→Blinking
→Green
Green Blinking→Count
Green
- -
KV-S3065CLSERIES / KV-S3065CWSERIES
Remarks