Operation - Panasonic KV-S3065CL SERIES Service Manual

KV-S3065CLSERIES / KV-S3065CWSERIES
9.3.

Operation

This section describes each operation (or status indication), according to the function item list shown in Sec.9.2.
9.3.1. Scanner Status
This function indicates scanner status, updating it every few seconds.
The status messages and its contents are as follows.
Classified
Code
- Scanner has no error.
U11, U12, Jam occurred!
U13, U14, Please open the door and remove the paper.
U15, U16, U17
U18 Paper remains in the Scanner.
Please open the door and remove the paper.
U20 Skew error occurred!
U23 Double Feed occurred!
Please open the door and remove the paper.
U30 Scanner Door is open!
Please close the door.
U32 Scanner Door is open!
Please close the door.
U34 Scanner Door is open!
Please close the door.
Fxx System error occurred!
Please consult with a service representative.
- No Paper!
Please set the paper.
- *** Warning ***
The rollers need to be cleaned.
Please clean the rollers.
Please select Clear Counter button after
cleaning rollers.
- *** Warning ***
The rollers need to be replaced.
Please replace the rollers.
Please select Clear Counter button after
replacing the rollers.
- *** Warning ***
Insufficient front light error occurred.
The lamp and/or scanning sensor need to be
replaced.
- *** Warning ***
Insufficient back light error occurred.
The lamp and/or scanning sensor need to be
replaced.
- *** Warning ***
Please clean the surface of the image sensor
cover.
- Scanner is not connected!
Status Message
Fig.9.3.1 Scanner Status
No error
U11: Paper feed jam
U12: Conveyor jam 1 (Paper did not reach the Starting Sensor.)
U13: Conveyor jam 2 (Paper did not reach the Paper Jam Sensor.)
U14: Conveyor jam 3 (Paper did not reach the Ending (Front) Sensor.)
U15: Conveyor jam 4 (Paper did not reach the Ending (Rear) Sensor.)
U16: Exit jam 1 (Paper did not go out of the Ending (Front) Sensor
throughout.)
U17: Exit jam 2 (Paper did not go out of the Ending (Rear) Sensor
throughout.)
Document remains in scanner, or dust is attached around a sensor.
Skew error
Double feed error
Front Door is open.
Post-imprinter Door is open.
Pre-imprinter Door is open.
Service-person call level error occurred.
No paper error
Warning for cleaning rollers.
Warning for replacing rollers.
1. The lamp have reached its life expectancy.
2. Lamp drive circuit for the front does not work properly.
1. The lamp have reached its life expectancy.
2. Lamp drive circuit for the back does not work properly.
The surface of Image Sensor Cover is dirty.
Scanner is not connected to PC properly.
82
Contents