Setting The Scanner.11 - Panasonic KV-S6040W Operating Instructions Manual

Display Panel Instructions
■Setting the scanner
The following parameters can be customized using the scanner's various setting modes. If the application
software provides these features, it will be supported by the scanner.
Scan menu
Item
Contents
Front side brightness
Selection for density when scanning the front side of a document.
Front side image emphasis
Selection for emphasis when scanning the front side of a document.
Front side contrast
Selection for contrast when scanning the front side of a document.
Front side halftone Selection for gradation when scanning the front side of a document.
Back side brightness
(For KV-S6045W only)
Selection for density when scanning the back side of a document.
Back side image emphasis
(For KV-S6045W only)
Selection for emphasis when scanning the back side of a document.
Back side contrast
(For KV-S6045W only)
Selection for contrast when scanning the back side of a document.
Back side halftone
(For KV-S6045W only)
Selection for gradation when scanning the back side of a document.
Noise reduction Selection for noise reduction when scanning a document.
Double feed detection
Selection to detect double feeding function.
When scanning very important documents, confirm tf the number of scanned
pages displayed on the LCD matches the number of actual pages.
Feed speed
Selection for feed speed when a document is being scanned.
Black line removal
Selection to remove the black lines which appear at the top and bottom
of the image after scanning the document.
Scanning mode
Selects whether documents are scanned at actual size or reduced (Fit to
Page) side.
Scanning method
Selects the documents to be scanned either the ones placed on the ADF
or the ones placed on the flatbed.
Save "Scanning Settings"
(Select memory)
Selects the memory where the conditions are saved.
Save "Scanning Settings"
(Execution)
Saves the scanning conditions into the memory. (2 memory settings)
Load scanning setting
Loads the memory where the scanning conditions have already been
saved. If "Default" is selected, all of the scanning conditions will return
to the default values.
Counter menu
Item
Contents
Select the counter displayed
on the LCD
Selection to display the cleared counter (scan counter) after scanning
one time or to display the user set counter (user counter) on the LCD.
Setting the user counter Selection for default number before scanning.
Setting the "User Counter
Extender"
Selection for an increase number of extender in the default number.
Clear the "User Counter"
Clears the counter which was set by the user.