Panasonic KV-S3065CL SERIES Service Manual page 241

4.3. "Section 9.3 Operation"
This section describes each operation (or status indication), according to the function item list shown in Sec.9.2.
4.3.1. "Section 9.3.1 Scanner Status"
This function indicates scanner status, updating it every few seconds.
The status messages and its contents are as follows.
Classified
Code
— Scanner has no error.
U11, U12, A paper jam has occurred.
Open the scanner's door, remove the
U13, U14,
documents, and close the cover. Place the
U15, U16,
U17
documents back in the document feed tray.
Paper remains in the scanner.
U18
Open the scanner's door, remove the
documents, and close the cover. Place the
documents back in the document feed tray.
U20 A skew error has occurred.
Open the scanner's door, remove the
documents, and close the cover. Place the
documents back in the document feed tray.
U23 A paper double feed has occurred.
Open the scanner's door, remove the
documents, and close the cover. Place the
documents back in the document feed tray.
U30 Scanner Door is open!
Please close the door.
U32 Scanner Door is open!
Please close the door.
U34 Scanner Door is open!
Please close the door.
Fxx System error occurred!
Please consult with a service representative.
— *** Warning***
The rollers need to be cleaned.
Please clean the rollers. Please select Clear Counter
button after cleaning rollers.
— ***Warning***
The replaceable rollers (consumable) are
close to reaching their usable life.
To insure reliable operation, please replace
these rollers with Roller Exchange Kit for your
specific scanner. After replacing the rollers,
select the "Clear Counter" button.
— ***Warning***
Insufficient front light error occurred. The lamp
and/or scanning sensor need to be replaced.
— ***Warning***
Insufficient back light error occurred. The lamp
and/or scanning sensor need to be replaced.
— ***Warning***
The scanner's image sensor cover is dirty and
requires routine cleaning. To insure reliable
scanning quality, open the scanner's door
and carefully clean the scanner's image
sensor cover.
— Scanner is not connected!
Status Message
Fig. 9.3.1 Scanner Status
No error
U11: Paper feed Jam
U12: Conveyor jam1 (Paper did not reach the Starting Sensor)
U13:Conveyor jam2 (Paper did not reach the Paper Jam Sensor)
U14: Conveyor jam3 (Paper did not reach the Ending (Front) Sensor.)
U15: Conveyor jam 4 (Paper did not reach the Ending (Rear) Sensor.)
U16: Exit jam 1 (Paper did not go out of the Ending (Front) Sensor
throughout)
U17: Exit Jam2 (Paper did not go out of the Ending (Rear) Sensor
throughout)
Document remains in the scanner, or dust is attached around a sensor.
Skew error
Double feed error
Front Door is open.
Post-imprinter Door is open.
Pre-imprinter Door is open.
Service-person call level error occurred.
Warning for cleaning rollers.
Warning for replacing rollers.
1. The lamp have reached its life expectancy.
2. Lamp drive circuit for the front does not work properly.
1. The lamp have reached its life expectancy.
2. Lamp drive circuit for the back does not work properly.
The surface of Image Sensor Cover is dirty.
Scanner is not connected to PC properly.
10
Contents