JRC JMA-7710-6 Instruction Manual page 88

3.3
To set the radar alarm zone
1. Press the
Procedures Procedures
2. Press the
3. Pressing the
4. Turn the EBL and VRM controls to set the radar alarm range and press
the
Use EBL1 to set the originating point of the angle, EBL2 to set the end point of the
angle or VRM1 to set the range.
Note
G The width of the radar alarm range is fixed.
Do not use the floating EBL for EBL2 being set.
Motion for radar alarm set zone
There are two modes, namely, "IN" mode in which an alarm goes off when a target enters the set circular
radar alarm zone and "OUT" mode in which an alarm goes off when a target goes out of the zone.
The radar alarm set zone is displayed only in the radar transmission mode. Note that it is not displayed
in the standby mode.
To set the alarm mode
Specify whether to output an alarm when a target enters or goes out of the radar alarm set zone.
1. Press the
Procedures
Procedures
2. Press the
3. Press the
4. Press the
Exit 5. Press the
Exit
GZ
key to open RADAR ALARM menu.
MENU
3
key to select "RADAR SECTOR ZONE".
ENT
key clears the menu and displays the radar screen.
ENT
key.
GZ
key to open RADAR ALARM menu.
MENU
2
key to select "RADAR ALARM MODE".
2
key to select "IN" or "OUT".
ENT
key to confirm the setting.
GZ
key.
MENU
3 – 29