JRC JMA-7710-6 Instruction Manual page 165

5.1
[II] Displaying the ring of the CPA (range of safety limit)
The CPA ring is displayed only in the relative vector mode. It is not displayed in the true vector mode.
(Refer to subsection "5.4.1 Vector Display".)
1. Press the
Procedures
2. Press the
3. Press
4. Press the
The CPA ring is set to ON. The CPA ring is displayed on the screen. To erase the
display of the CPA ring, press the
5. Press the
Exit
ATA #2
ATA #2
1. AUDIBLE WARNING
CPA
LOST TARGET
2. DISPLAY OF CPA RING
3. ATA TEST MENU
4. SIMULATION
SUB
key to open the SUB MENU.
MENU
5
9
and
2
key to select "DISPLAY OF CPA RING".
2
key and then press the
SUB
key.
MENU
TCPA OFF ON
OFF ON
OFF ON
OFF STOP NEAR
5 – 3
key to open the ATA #2 menu.
ENT
key.
ENT
2
key and
FAR
key again.
0. PREV