Displaying Plot Numerical Data - JRC JMA-7710-6 Instruction Manual

3.3

3.3.23.4 Displaying Plot Numerical Data

Attention
The following data is displayed for the specified plot.
Plot No:
Elapsed time:
Target bearing:
Distance to target:
Target true course: In 1 degree
Target true speed:
CPA:
TCPA:
The TCPA of the plot leaving from the own ship is displayed with "–".
1. Press the
Procedures
Procedures
2. Enter the plot No. using a numeric key (
3. Press the
The symbol of the target whose data is displayed turns to "
To delete data display
1. Press the
Procedures
Procedures
2. Press the
Note 1
G The vector time and vector mode information are always displayed on the screen.
Note 2
G "U" is displayed near the mark of the target for which the plot has not been updated for more than 10
minutes and an alarm for requesting update goes off.
G The target which has not been updated for more that 15 minutes is automatically deleted.
Target No.
In 0.1 minute
In 1 degree
In 0.01nm
In 0.1KT
In 0.01nm
In 0.1 minute
TGT
key to enable the plot No. to be entered.
DATA
key to display the data of the specified plot.
TGT
key.
DATA
key to delete the numerical data.
3 – 45
9
0 to ).
".