Sensor Test; Line Test - JRC JMA-7710-6 Instruction Manual

8.1.2.3 Sensor Test

This test is used to check signals from the scanner unit.
1. Follow procedures 1 to 2 in subsection 8.1.2.1.
Procedures
Procedures
2. Press the
3. Press the
"OK" is displayed when the bearing pulses (BP and BZ) are input in the display unit.
Exit 4. Press the
Exit
Sensor Test
SENSOR
TEST
SAFETY KEY
BEARING PULSE (BP)
BEARING PULSE (BZ)

8.1.2.4 Line Test

This test is used to check the communication status with optional equipment.
1. Follow procedures 1 to 2 in subsection 8.1.2.3.
Procedures Procedures
The DIAGNOSTIC 1 menu appears.
2. Press the
"ON" appears when communication or connection has been established.
Exit 3. Press the
Exit
Line Test
LINE TEST
NSK
UART1
UART2
ATA
2
key to open the DIAGNOSTIC 1 menu.
1
key to open the SENSOR TEST menu.
SUB
key.
MENU
OK
OK
OK
2
key to open the LINE TEST menu.
SUB
key.
MENU
ON
ON
OFF
ON
8 – 4
8.1
0. PREV
8
0. PREV