JRC JMA-7710-6 Instruction Manual page 175

5.4
[II] Vector Length
The vector length becomes the length proportional to the speed of the target and the length can be switched
from 1 to 60 minutes.
The example shown in the following diagram shows the case where the vector length is six minutes, and the
vector tip becomes the forecast position after six minutes.
Setting the vector length
1. Press the
Procedures
Procedures
2. Press the
3. Press the
4. Press the
5. Press the
The vector time is fixed. The time of the vector is displayed on the lower right of the
screen.
6. Press the
Exit Exit
or
1. Whenever the
Procedures Procedures
of one minute.
2 Whenever the
of one minute.
HL
Current position
SUB
key to open the SUB MENU.
MENU
5
key to open the ATA #1 menu.
2
key twice to select "VECTOR TIME".
0 9
to keys to set the time of the vector length.
ENT
key.
SUB
key.
MENU
VECT+
key is pressed, the vector time is increased in units
VECT–
key is pressed, the vector time is decreased in units
DEST
5 – 13
Expected position
(e.g., after 6 minutes)