Sensor Test; Line Test - JRC JMA-3910-4 Instruction Manual

7.1.2.3 Sensor Test

This test is used to check signals from the scanner unit.
1. Follow procedures 1 to 3 in subsection 7.1.2.1.
Procedures
The DIAGNOSTIC MENU appears.
2. Press the
"OK" is displayed when the bearing pulses (BP and BZ) are input in the display unit.
Exit 3. Press the
Sensor Test
SENSOR TEST
0. PREVIOUS MENU
SAFETY SWITCH
BEARING PULSE (BP)
BEARING PULSE (BZ)
To close this menu, Press (SUB MENU) key.

7.1.2.4 Line Test

This test is used to check the communication status with optional equipment.
1. Follow procedures 1 to 3 in subsection 7.1.2.1.
Procedures
The DIAGNOSTIC MENU appears.
2. Press the
"ON" appears when communication or connection has been established.
Exit 3. Press the
Line Test
LINE TEST
0. PREVIOUS MENU
NSK
UART1
UART2
ARPA
To close this menu, Press (SUB MENU) key.
3
key to open the SENSOR TEST menu.
SUB
key.
MENU
ON
OK
OK
4
key to open the LINE TEST menu.
SUB
key.
MENU
ON
ON
OFF
ON
7 – 4
7.1
7