1. INSTALLATION OF UNITS
1.3
Rudder Reference Unit FAP-6112
• Leave sufficient space around all moving parts.
• The unit must be coupled to the rudder as shown below, where the following conditions
are satisfied:
Use four self-tapping screws (supplied) to fasten the rudder reference unit.
350 mm <Y2 < 540 mm
X1 = X2
Y1 = Y2
Note:
The arm of rudder reference unit should be aligned with the arrow mark. Align the
notch on the shaft to the arrow mark if the arm is removed.
1-4
X1
Arrow mark
Y2
90
Y1
Top view
X2