Operation - Hilti SID Operating Instructions Manual

6.2.2 Charging a previously used battery
Ensure that the outer surfaces of the battery are clean and dry
before inserting it in the corresponding charger.
Read the operating instructions for the charger for further inform-
ation about the charging procedure.
Lithium-ion battery packs are ready to use at any time, even when
only partially charged. Charging progress is indicated by the LED
display (see charger operating instructions).
6.3 Fitting the battery
CAUTION
Before fitting the battery, check that the power tool is switched
off and that the safety lock is engaged (forward/reverse switch
in the middle position). Use only the Hilti batteries approved
for use with this power tool.
CAUTION
Check that the terminals on the battery and in the power tool
are free from foreign objects before inserting the battery in
the power tool.
1. Push the battery into the power tool from the rear as far as it
will go and until it is heard to engage with a double click.
2. CAUTION If it is not fitted securely, the battery could fall
out while you are working with the tool.
CAUTION A falling battery may present a risk of injury to
yourself or others.
Before beginning the work, check that the battery is fitted
securely to the tool.
6.4 Removing the battery
1. Press one or both release buttons.
2. Pull the battery out of the power tool toward the rear.
6.5 Transport and storage of battery packs
Pull the battery pack out of the locked position (working position)
and move it into the first click-stop position (transport position).
If you disconnect a battery pack from the power tool for transport
or storage, make sure that the contacts of the battery pack are
not short-circuited. Remove loose metal parts such as screws,
nails, clamps, loose screw bits, wires or metal swarf from the case,
toolbox or transport container, or prevent these parts from coming
into contact with the battery packs.
Observe national and international transport regulations when
shipping battery packs (transportation by road, rail, sea or air).

7 Operation

7.1 Changing insert tools
CAUTION
Wear protective gloves when changing insert tools as the
insert tools get hot during use.
Check that the connection end of the insert tool is clean. Clean
the connection end if necessary.
7.1.1 Changing insert tools with the SID 14-A and SID 22-A
NOTE
The power tool is equipped with a ¹/₄" hex. socket chuck with
locking ring.
7.1.1.1 Fitting the screwdriving bit
1. Set the forward / reverse switch to the middle position or
remove the battery from the power tool.
2. Push the bit into the chuck as far as it will go (until it engages).
7.1.1.2 Removing the screwdriving bit
1. Set the forward / reverse switch to the middle position or
remove the battery from the power tool.
2. Pull the locking ring on the chuck forward and hold it in this
position.
3. Pull the screwdriving bit out of the chuck and then release the
locking ring.
Printed: 19.09.2013 | Doc-Nr: PUB / 5071637 / 000 / 02
2
3
4
en
25