Technical Data; Operation - Hilti SD 2500 Manual

Bit holder
@
Chuck
;
Power tool / accessory interface (snap-on
=
connection)
Coupling system / gearing
%
Belt hook
&
Motor
(
Air intake
)
3.2 Intended use
The product described is a hand-held mains-powered electric tool for use in drywall installation.
The power tool is designed for driving and removing screws in drywall installation work. Drywall screws with
a length of up to 55 mm and a diameter of up to 4.2 mm can be used.
Working with materials hazardous to health (e.g. asbestos) is not permissible.
3.3 Items supplied
Drywall screwdriver, operating instructions
You can find other system products approved for use with your product at your local Hilti Center or
online at: www.hilti.com.
4

Technical data

4.1 Technical data
Rated current input
Weight
Rated speed under no
load
Max. torque
Socket/bit drive
5

Operation

5.1 Preparations at the workplace
CAUTION
Risk of injury! Inadvertent starting of the product.
▶ Unplug the supply cord before making adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1.1 Working safely with the universal hook
▶ Before beginning the work, make sure that the universal hook is securely attached to the screwdriver.
▶ Lay the screwdriver down in a safe place when it is not in use for a long period.
5.1.2 Forward / reverse
The control switch is locked when the forward / reverse switch is in the middle position (safety lock).
6 English
Printed: 22.10.2018 | Doc-Nr: PUB / 5135890 / 000 / 03
SD 4500
6.5 A
1.4 kg
(3.1 lb)
0 /min ... 4,500 /min
9.5 Nm
Hex socket / "
1
4
Forward/reverse switch
+
Lockbutton for continuous operation
§
On / off switch
/
Supply cord
:
Type identification plate
∙
Air exit
$
Depth gauge
£
SD 2500
3.3 A
1.5 kg
(3.3 lb)
0 /min ... 2,500 /min
19 Nm
Hex socket
1
/ "
4