Operation - Hilti SD 2500 Manual

Drywall screwdriver
Hide thumbs Also See for SD 2500:
Table of Contents

Advertisement

Available languages

Available languages

5

Operation

5.1
Preparations at the workplace
CAUTION
Risk of injury! Inadvertent starting of the product.
▶ Unplug the supply cord before making adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1.1
Working safely with the universal hook
▶ Before beginning the work, make sure that the universal hook is securely attached to the screwdriver.
▶ Lay the screwdriver down in a safe place when it is not in use for a long period.
5.1.2
Forward / reverse
The control switch is locked when the forward / reverse switch is in the middle position (safety lock).
▶ Set the forward / reverse selector switch to forward or reverse rotation.
5.2
Changing the accessory tool.
1. Pull the depth gauge away from the power tool, releasing the snap-on connection.
2. Push the chuck towards the screwdriver, turning the chuck slightly at the same time, and then hold it in
this position.
3. Remove the accessory tool with your other hand.
4. Insert the desired accessory tool in the chuck, pushing it into the screwdriver as far as it will go.
5.3
Types of work
Observe the safety instructions and warnings in this documentation and on the product.
5.3.1
Driving screws
WARNING
Electrical hazards There is a risk of electric shock if a screw is driven into a concealed electric cable and,
at the same time, the bit holder or depth gauge is touched.
▶ Hold the screwdriver only by the grip when driving or removing screws.
1. Set the screwdriver to forward rotation.
2. Position the screw on the bit and bring the tip of the screw into contact with the working surface.
The optimum screwdriving depth can be set by turning the depth gauge.
3. Use the control switch to regulate the speed of the screwdriver.
5.3.2
Removing screws
1. Pull the depth gauge off.
2. Set the screwdriver to reverse rotation.
3. Insert the bit in the head of the screw and use the control switch to regulate the speed of the screwdriver.
4. Refit the depth gauge after removing the screws.
5.3.3
Switching on in sustained operating mode
▶ Switch on in sustained operating mode.
5.3.4
Switching off after sustained operation
▶ Press the control switch.
◁ The lockbutton returns to its original position.
6
English
Printed: 22.10.2018 | Doc-Nr: PUB / 5135889 / 000 / 03
2
3
4
2021357
*2021357*

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sd 4500

Table of Contents