Chapter 3 Replacement Procedure - Pro-face GP-2500 Series Replacement Manualbook

Chapter 3 Replacement Procedure

3.1 Work Flow ow
Installation
Check the compatibility of
hardware in Chapter 2.
Remove GP2000 series.
Install GP4000 series.
Connect the power cord.
Check the performance
and start operation.
*1: This step is required if screen data is saved only in the GP unit, not in any other device.
Screen
Check the differences of
specifications in OtasukePro!
[Compatibility of Software]
(http://www.pro-face.com/o
tasuke/qa/gp3000/replace/s
oft/conv/care/3/).
Receive screen data from
GP2000 series. *1
Convert GP2000 series
screen data with GP-Pro
EX's Project Converter.
Check and modify the data
on GP-Pro EX.
Transfer the screen data to
GP4000 series.
25/61
Communication
Check the connection
between GP4000 series
and a PLC in the GP-Pro EX
Device/PLC Connection
Manual.
Connect GP4000 series
and PLC with the PLC's
Start connection and check
the communication.