M Ultilink C Onnection - Pro-face GP-2500 Series Replacement Manualbook

4.4 Multilink Connection
For GP4000 series, some communication driver
(n: 1) via RS-422.
When converting the project file with the setting of the communication driver that
does not support multi-link connection (n:1) via RS-422, the connection is
automatically converted to (1:1).
For the communication drivers that support serial multi-link, see
support serial multilink
(http://www.pro-face.com/otasuke/files/manual/gpproex/new/device/com_mlnk.ht
m).
4.5 Cable Diagram at the time of replacement
The connection cable for GP2000 series can be used for GP4000 series.
But please note that there are precautions and restrictions as described below .
IMPORTANT
Please check the con
・
EX Device/PLC Connection Manual before using a connection cable.
(http://www.pro-face.com/otasuke/files/manual/gpproex/new/device/index.ht
m)
・ The Siemens MPI connection cable cannot be used.
Please refer to the above-mentioned GP-Pro EX Device/PLC Connection Manual
and prepare a connection cable for GP4000 series newly.
communication?]
nection configurations GP4000 series supports with GP-Pro
54/61
s do not support multi-link connection
[Which drivers