Chapter 3 Replacement Procedure; Work Flow - Pro-face GP-577R Series Replacement Manualbook

Chapter 3 Replacement Procedure

3.1 Work Flow

ow
Installation
Check the compatibility of
hardware in Chapter 2.
Remove GP-577RT/S.
Install GP-4501T/TW.
Connect the power cord.
Check the performance
and start operation.
*1: This step is required if screen data is saved only in the GP unit, not in any other device.
Screen
Check the differences of
specifications in
OtasukePro! [Compatibility
of Software]
(http://www.pro-face.com/
otasuke/qa/gp3000/replace
/soft/conv/care/3/).
Receive screen data from
GP-577RT/S. *1
Convert GP-577RT/S screen
data with GP-Pro EX's
Project Converter.
Check and modify the data
on GP-Pro EX.
Transfer the screen data to
GP-4501T/TW.
17/48
Communication
Check the connection
between GP-4501T/TW
and a PLC in the GP-Pro EX
Device/PLC Connection
Manual.
Connect GP-4501T/TW
and PLC with the PLC's
cable.
Start connection and check
the communication.