Chapter 3 Replacement Procedure; Work Flow - Pro-face GP3000 Series Replacement Manualbook

Chapter 3 Replacement Procedure

3.1 Work Flow

Installation
Check the compatibility of
hardware in Chapter 2.
Remove GP/ST3000
series.
Process the panel.
Install GP-4301TM.
Connect the power cord.
Check the performance
and start operation.
*1: This step is required if screen data is saved only in the display unit, not in any other device.
Screen
Check the restrictions for
GP-4301TM with GP-Pro EX
Reference Manual.
Receive screen data from
GP/ST3000 series *1
Change the received data
on GP-Pro EX.
Check and modify the data
on GP-Pro EX.
Transfer the screen data to
GP-4301TM.
19/40
Communication
Check the connection
between GP-4301TM and a
PLC in the GP-Pro EX
Device/PLC Connection
Manual.
Connect GP-4301TM and
the PLC with a cable.
Start connection and check
the communication.