Chapter 3 Replacement Procedure
3.1 Work Flow
Installation
Check the compatibility of
hardware in Chapter 2.
Remove GP-477RE.
Install GP-4501T/TW.
Connect the power cord.
Check the performance
and start operation.
*1:
This step is required if screen data is saved only in the GP unit, not in any other device.
Screen
Check the differences of
specifications in
OtasukePro!
[Compatibility
of
Software]
(http://www.pro-face.com/
otasuke/qa/gp3000/replace
/soft/conv/care/3/).
Receive screen data from
GP-477RE.
*1
Convert GP-477RE screen
data with GP-Pro EX's
Project Converter.
Check and modify the data
on GP-Pro EX.
Transfer the screen data to
GP-4501T/TW.
21/55
Communication
Check the connection
between GP-4501TW and a
PLC in the GP-Pro EX
Device/PLC Connection
Manual.
Connect GP-4501T/TW
and PLC with the PLC's
cable.
Start connection and check
the communication.