Connection; Operations - IDTECK SR10S User Manual

9. Connection

10. Operations

10-1. When power is applied, the SR10S beeps and turns on the LEDs in the order of red > green > red >
green. Then, the LEDs turn off for a while and turn on in red again, one by one, from left to right while
the buzzer beeps.
(After power-on, the SR10S goes into the stand-by state and waits to read the serial number of a card
presented to the unit.)
10-2. Bring a card closer to the unit until the buzzer beeps and the green LEDs turn on, one by one. After the
card is recognized properly, the unit will send the card data to the controller and return to the stand-by
state with red LEDs on.
 After a successful operation is completed, the buzzer beeps once and the red LEDs turn off and, then,
the green LEDs turn on, one by one, from the left. After all of the 3 LEDs turn off, the LEDs turn red.
 If an operation isn't successfully completed (i.e. if an error occurs), the buzzer beeps twice and the
red LEDs blink at once.
 If the PRG2000S does NOT operate as described above, refer to 11. Appendix.
10-3. LED Control
You can control the LED of the device at your preference.
Connect the LED Control Input wire (Yellow wire) to the NO port of controller relay output, and GND
9