How To Setup The Feeder; Figure 8: Adjusting The Separation - Neopost AS-930 User Manual

5.3 How to setup the feeder

To setup the feeder you need to perform the following steps in this order:
1. Adjust the separation
2. Adjust the transport roller height
3. Adjust the paper side guides
4. Fill the feeder with material
5. Adjust the paper feed ramp
1. Adjust the
separation
separator
medium
28
• Open the fixing screws of both separators and lift them.
• Depending on you medium put one or two pieces under all four
separation fingers.
Thin medium (e.g. single sheets with 100 g/m²)
= two pieces under the fingers
Envelopes
= put the thickest part of the envelope (= flap) under the fingers
When using a narrow medium put two or more pieces next to each
other so that there is material under each separation finger.
Setup all separation fingers
Make sure that there is a medium under each
separation finger. Otherwise unused fingers could
wear the feed rollers (see Figure 9).
• Drop the separation fingers so that they sit on the medium.
• Lock both fixing screws.
• Pull out the medium.
fixing screw

Figure 8: Adjusting the separation

separation
fingers
User Manual Version 3.1