Section 4 - Software Setup Information; General Software Setup Info - Neopost AS-970C User Manual

Section 4 – Software Setup Information

General Software Setup Info

Note: The following information assumes you have the Printer Driver version 12.01 or higher
installed on computer system and firmware version 20130820 or higher installed on printer.
Do NOT exceed the Min or Max media specifications of the printer:
•
Minimum paper size printer can feed: 3" wide x 4.13" long.
•
Maximum paper size printer can feed: 9.5" wide x 17" long.
Tip: Set the Media Registration Side Guide to accommodate your media width.
- Inner position for media measuring 3" to 8.5" in width.
- Outer position for media measuring 8.6" to 9.5" in width.
•
Maximum print area for the printer: 8.5" wide x 17" long.
NOTE: Driver version R12.01 will accept up to a 30" height, but the rear media guide is not
designed to support media of this length.
Software Setup for media that is 3" to 8.5" wide:
Set the paper width to the actual width of your media. Set the paper length to the actual length of
your media. Set the paper size within the "Printer Driver" to match the paper size set in your software.
Examples:
8.5" x 11" document: Select "Letter" or set a custom paper size of 8.5" wide by 11" long, in
software and driver. Set top, bottom, left and right margins to minimum values, or any margin you
require. Set Portrait orientation in software and driver.
# 10 envelope (4.13" W x 9.5" L) feeding short side first: Select "Env. Com10 4 1/8 x 9 1/2 in –
Landscape", in software and driver. Set top, bottom, left and right margins to minimum values, or
any margin you require. Set Landscape orientation in software and portrait orientation driver.
Software Setup for media that is 8.6" to 9.5" wide:
Using Custom Paper size; set the paper width to 8.5". Set the paper length to the actual length of
your media. Set the paper size within the "Printer Driver" to match the paper size set in your
software.
Examples:
9.5" x 17" document: Set a custom paper size of 8.5" wide by 17" long. Set top, bottom, left and
right margins to minimum values, or any margin you require.
# 10 envelope (9.5" W x 4.13" L) feeding flap first: Set a custom paper size of 8.5" wide by 4.13"
long. Set top, bottom, left and right margins to minimum values, or any margin you require.
SOFTWARE SETUP INFORMATION
SECTION 4
53