How To Setup The Feeder; Figure 10: Adjusting The Separation - Neopost AS-710 User Manual

5.3 How to setup the feeder

To setup the feeder you need to perform the following steps in this order:
1. Adjust the separation
2. Adjust the paper side guides
3. Fill the feeder with material
4. Adjust the paper feed ramp
1. Adjust
•
the
•
separation
•
•
•
•
•
•
•
User Manual Version 3.1
Unlock the separation lock knob (A) by turning it counter-clockwise.
Set both separation adjustment knobs (B) to the mid-position. The mid-
position is indicated by the two arrows
Lift the complete separation by pulling the separation lock knob (A)
upwards.
Depending on your medium put one or two pieces under all four
separation fingers (see Figure 11).
Thin medium (e.g. single sheets with 100 g/m²)
= two pieces under the fingers
Envelopes
= put the thickest part of the envelope (= flap) under the fingers
When using a narrow medium put two or more pieces next to each
other so that there is material under each separation finger.
Setup all separation fingers
Make sure that there is a medium under each separation
finger. Otherwise unused fingers could wear the feed
roller.
Drop the separation fingers so that they sit on the medium.
Lock the separation lock knob (A) by turning it clockwise. Now the
separation fingers are fixed at the correct height.
Pull out the medium.
If the paper becomes skewed as it is pulled in, make fine adjustments
with the separation adjustment knobs (B).
B

Figure 10: Adjusting the separation

.
A B
33