Starter Pulley (Except For Usa) And Cdi Magneto - Yamaha YFM250XL(C) Service Manual

ENGINE ASSEMBLY AND ADJUSTMENT
STARTER PULLEY (EXCEPT FOR USA) AND
CDI MAGNETO
1.Inspect:
Timing chain 1
Chain guide 2 (intake)
Chain guide (intake):
8 Nm (0.8 m • kg, 5.8 ft • lb)
NOTE:
Fasten a safety wire 3 to the timing chain
to prevent it from falling into the crankcase.
2.Install:
Washer 1
Driven gear 2 (starter)
Woodruff key 3
CDI magneto 4
NOTE:
Clean the tapered portions of the crank-
shaft and CDI magneto.
When installing the CDI magneto, make
sure the key is properly seated in the key
way of the crankshaft, and install the CDI
magneto 4 to the crankshaft, then while
holding the starter driven gear 2, set the
CDI magneto to the driven gear, turn it
counterclockwise.
3.Install:
Idle gear 1 (starter)
Washer 2
Shaft 3
Dowel pins 4
Gasket 5
WARNING
Always use a new gasket.
4.Install:
Crankcase cover 1 (left)
Screws
Screw (crankcase cover/crank-
case spacer):
7 Nm (0.7 m • kg, 5.1 ft • lb)
4 - 63
ENG
4