Chassis; Front Brake Fluid Level Inspection; Front Brake Pad Inspection - Yamaha YFM250XL(C) Service Manual

Yfm250xl(c) yamaha
Table of Contents

Advertisement

FRONT BRAKE FLUID LEVEL INSPECTION/

FRONT BRAKE PAD INSPECTION

a

CHASSIS

FRONT BRAKE FLUID LEVEL INSPECTION
1.Place the machine on a level surface.
NOTE:
When inspecting the front brake fluid level,
make sure that the top of the master cylinder
top is horizontal.
2.Inspect:
Brake fluid level
Fluid level is under "LOWER" level line a
→ Fill up.
Recommended brake fluid:
DOT 4
NOTE:
If DOT 4 is not available, DOT 3 can be used.
CAUTION:
Brake fluid may erode painted surfaces or
plastic parts. Always clean up spilled fluid
immediately.
WARNING
Use only the recommended brake fluid;
otherwise, the rubber seals may deterio-
rate, causing leakage and poor brake per-
formance.
Refill with the same type of brake fluid;
mixing fluids may result in a harmful
chemical reaction and lead to poor per-
formance.
Be careful that water does not enter the
master cylinder when refilling. Water will
significantly lower the boiling point of the
fluid and may result in a vapor lock.
FRONT BRAKE PAD INSPECTION
1.Remove:
Front wheel
2.Inspect:
Brake pad
Wear indicators 1 almost touch the brake
disc → Replace the brake pads as a set.
Refer to "FRONT BRAKE".
3.Operate the brake lever.
4.Install:
Front wheel
– 17 –
INSP
ADJ

Advertisement

Table of Contents
loading

This manual is also suitable for:

Yfm250xlYfm250xc

Table of Contents