Yamaha YFM250XL(C) Service Manual page 388

1 Rectifier/regulator
2 CDI unit
3 Starting circuit cut-off relay lead
4 Starter relay lead
5 Starter motor lead
6 Starting circuit cut-off relay
7 Starter relay
8 Rear brake breather hose
9 Carburetor air vent hose
0 Final gear case breather hose
CABLE ROUTING
È Fasten the battery + lead and starter motor lead
to the rear fender with the plastic clamps.
É Install the starter circuit cut-off relay onto the tab
with its terminal side facing down.
Ê Fasten the wire harness and starter motor lead
to the frame with the plastic locking tie.
Ë Install the starter relay onto the tabs with its ter-
minal side facing up.
Ì Fasten the battery breather hose to the rear
fender with the plastic clamp and then insert the
clamp into the hole in the rear fender.
– 9 –
SPEC