Drive Select Lever Position Adjustment; Final Drive Gear Oil Level Inspection - Yamaha YFM250XL(C) Service Manual

DRIVE SELECT LEVER POSITION ADJUSTMENT/

FINAL DRIVE GEAR OIL LEVEL INSPECTION

DRIVE SELECT LEVER POSITION
ADJUSTMENT
1.Adjust:
Drive select lever position
**********************************
Adjustment steps:
Place the machine on a level place.
Shift the transmission in first gear, and
move the select lever 1 to reverse posi-
tion.
Loosen the locknuts 2.
Turn the select lever adjuster 3 in or out
until lever 4 center line a aligns with
match mark b on the crankcase cover.
Tighten the locknuts 2.
Locknut (select lever adjuster):
15 Nm (1.5 m • kg, 11 ft • lb)
NOTE:
After adjusting the drive select lever, be
sure the reverse indicator light comes on
when the drive select lever is in reverse
position.
**********************************
FINAL DRIVE GEAR OIL LEVEL INSPECTION
1.Inspect:
Final drive gear oil level
Oil level low → Add sufficient oil.
NOTE:
The engine should be cool (at atmospheric
temperature).
**********************************
Inspection steps:
Place the machine on a level place.
Place an oil pan under the final drive gear
case.
Remove the filler bolt 1 and copper
washer.
Visually check the oil level. Correct oil
level should be at the lower brim of the
hole.
3 - 29
INSP
ADJ
3