Inspection - Yamaha YFM250XL(C) Service Manual

FRONT WHEELS AND FRONT BRAKE
7 - 3
9.Remove:
Brake camshaft lever 1
Wear indicator plate 2
Brake camshaft 3
Brake camshaft holder 4
Pivot pin 5
Brake shoe plate 6

INSPECTION

1.Inspect:
Wheel
Refer to the "WHEEL INSPECTION" sec-
tion in CHAPTER 3.
2.Measure:
Wheel runout
Over specified limit → Replace wheel or
check bearing play 1.
Rim runout limits:
Vertical 2: 2.0 mm (0.08 in)
Lateral 3: 2.0 mm (0.08 in)
3.Inspect:
Tire surfaces
Wear/Damage → Replace.
Refer to the "TIRE INSPECTION" section
in CHAPTER 3.
NOTE:
Install the tire with the "ROTATION" mark
1 to the rotating direction.
WARNING
After replacing the tire, ride conservatively
to allow the tire to be properly seated in
the rim. Failure to do so may cause an acci-
dent resulting in machine damage and pos-
sible operator injury.
CHAS
7