Inspection And Disassembly - HYOSUNG WOW90 Service Manual

6-3 CHASSIS

INSPECTION AND DISASSEMBLY

◉ ◉ WHEEL HUB BEARING
Inspect the play of bearing inner ring by hand while
mounted in the wheel hub.
Rotate the inner ring by hand to inspect if any abnormal
noise occurs or it rotates smoothly.
Replace the bearing if there is anything unusual.
● Remove the spacer.
● Remove the inner and outer dust seals with the spe-
cial tool.
Oil seal remover : 09913 - 50121
CAUTION
The removed dust seal should be replaced with
new ones.
● Drive out the both bearings with the special tool in the
following procedures.
Wheel bearing remover : 09941 - 50111
● Insert the adapter into the bearing.
● After inserting the wedge bar from the opposite side,
lock the wedge bar in the slit of the adapter.
● Drive out the bearing by knocking the wedge bar.
CAUTION
The removed bearing should be replaced with new one.
◉ ◉ TIRE : Refer to page 2-11
◉ ◉ BRAKE DRUM
Measure the brake drum I.D. to determine the extent of
wear and, if the limit is exceeded by the wear noted,
replace the brake drum.
The value of this limit is indicated inside of drum.
Brake drum I.D.
Service limit
110.7 mm (4.358 in)