HYOSUNG WOW90 Service Manual page 118

Special tools Part Number∙Part Name∙Description
09910-20115
Conrod holder
Used to lock the crankshaft.
09910-32812
Crankshaft installer
Used to install the crankshaft in the crankcase.
09910-34510
Piston pin puller
Use to remove the piston pin.
09913-10760
Fuel level gauge
Measure height of carburetor.
09913-50121
Oil seal remover
Used to remove the oil seal.
09913-70122
Bearing installer
Used to drive bearing in.
09913-75520
Bearing installer
Used to drive bearing in.
09913-75820
Bearing installer
Used to drive bearing in.
09913-75830
Bearing installer
Used to install rear axle shaft oil seal.
SERVICING INFORMATION 7-6
Special tools Part Number∙Part Name∙Description
09913-76010
Bearing installer
Used to drive crankshaft bearing in.
09913-80112
Bearing installer
Used to drive bearing in.
09915-63310
Compression gauge adapter
Used with compression gauge.
09915-64510
Compression gauge
Measure cylinder compression.
09920-13120
Crankcase separater
Separate to crankcase.
09921-20200
Bearing remover(10mm)
Used to remove oil seal or bearing.
09921-20210
Bearing remover(12mm)
Used to remove oil seal or bearing.
09923-73210
Bearing remover(17mm)
Used to remove bearing with the rotor remove sliding shaft.
09923-74510
Bearing remover(20~35mm)
Used to remove bearing with the rotor remove sliding shaft.