HYOSUNG WOW90 Service Manual page 57

3-29 ENGINE
● Install the circlip ① on to the rear axle shaft ② .
● Assemble the idle shaft subassembly using the idle
shaft ③ and thrust washer ④, then install the sub-
assembly on the gear box.
● Install the final driven gear ⑤ on the rear axle shaft
using the circlip ⑥.
● Install the idle thrust washer ⑦, new gasket and
dowel pin ⑧.
● Install the driveshaft ⑨ to the gear box cover.
● Install the gear box cover ⑩ on the crankcase.
● Tighten all the screws evenly one by one in a diago-
nal fashion.
③
Center
Thrust
Circlip
�
Rounded coner
④