Toe-In Adjustment - HYOSUNG WOW90 Service Manual

6-11 CHASSIS

TOE-IN ADJUSTMENT

The procedure for adjusting the toe-in as follows.
● Place the vehicle on level ground and set the handle-
bar straight .
Make sure that all tires are inflated to the standard
pressure.
COLD INFLATION TIRE PRESSURE
kPa
Front 25
Rear 25
● Loosen the lock nuts ① on each tie-rod.
CAUTION
Inside lock nuts ① are left-hand thread.
● Measure the distances A and B of front wheels (in
illustration) and adjust the tie-rods, right and left, to
within the specified range.
Toe - in
NOTE :
A - B = Toe-in
● Temporarily tighten the four lock nuts.
● Check that the distances C and D ( in the illustration )
are equal. If the distances C and D are not equal,
readjust the tie-rod, right or left, whichever makes the
toe-in value closer to the specification. Check the toe-
in again by measuring the distances A and B.
● If the toe-in is not within specification, repeat the
adjustment as above until proper toe-in value is
obtained and at the same time the distances C and D
become equal.
● Tighten the four nuts ① after adjustment of toe-in is
made.
Tie-rod lock nut
: 22.4~35.7 Nㆍ ㆍ m (2.24~3.57 kgㆍ ㆍ m)
kgf/㎠ psi
0.25 3.6
0.25 3.6
8 mm (0.315 in)
Tire side
①
③
90�
� FRONT