HYOSUNG WOW90 Service Manual page 65

3-37 ENGINE
● Install the movable drive face cover ①.
CAUTION
Make sure that the movable drive plate is fully
positioned inside, or the weight roller may come
off.
● Insert the spacer ②.
● Position the movable drive face subassembly on the
crankshaft as shown in the photo.
CAUTION
Thoroughly clean the V-belt contact face to be
from oil.
● Install the fixed drive face ③ .
● Tighten the fixed drive face nut ④ to the specified
torque with the special tool.
Conrod holder : 09910-20115
Fixed drive face nut
● Continue turning the fixed drive face ⑤ by hand until
the V-belt is seated in and both the drive and driven
faces ⑥ will move together smoothly without slip.
● Fill the final gear box with transmission oil up to the
level hole.
Transmission
oil capacity
● Tighten the oil level bolt ⑦ to the specified torque.
Transmission oil level bolt
: 40~60 N ∙ ∙ m (4.0~6.0 kg ∙ ∙ m)
Replace
80 ㎖
Overhaul
90 ㎖
: 4~7 N ∙ ∙ m (0.4~0.7 kg ∙ ∙ m)