Crankcase - HYOSUNG WOW90 Service Manual

3-27 ENGINE
● Measure the length between the webs referring to the
figure at right when rebuilding the crankshaft.
Crank web to web width
● When mounting the crankshaft into the crankcase, it
is necessary to pull its left end into the crankcase
with the special tool.
Crankshaft installer : 09900-32812
Conrod holder : 09910-20116
CAUTION
Never fit the crankshaft into the crankcase by driv-
ing it with a plastic hammer. Always use the special
tool, otherwise crankshaft alignment accuracy will
be affected.

CRANKCASE

● Wipe the crankcase mating surfaces (both surfaces)
with cleaning solvent.
● Apply BOND "1215"uniformly to the mating surface
of the left half of the crankcase, and install the dowel
pins.
BOND "1215"
● Install the two dowel pins.
● Tighten the crankcase screws securely.
● Check if crankshaft rotates smoothly.
Standard
40.0 ± 0.1 mm
(1.575 ± 0.004 in)