Canon iR1600 Service Manual page 514

CHAPTER 3 DISASSEMBLY/ASSEMBLY
8) Remove the RAM DIMM/ROM
DIMM/EEPROM (IC4, 5) from the ex-
isting printer board, and mount them to
the same locations on the new printer
board.
If a ROM DIMM designed for
upgrading exists on the old
printer board, be sure that the
built-in ROM or the upgrading
ROM on the new printer board
are of the latest version.
9) Press the Additional Function key and
then the ID (#) key in the control panel
to start service mode.
10) Using the cursor key, select #8 PDL
(printer-related service mode).
11) Using the cursor key, select PDL-PCL
MENU, and press the OK key.
12) Using the cursor key, select SERVICE
MENU, and Press the OK key.
13) Go through the steps in F03-103-04.
14) Press the Go key to end service mode.
15) Turn off the power.
16) Mount the hard disk (option) and the
network board (option).
17) Turn on the power switch.
18) Enter necessary settings referring to
the TEST PRINT output in Steps 1)
and 2) and the Ethernet configuration
page (for machines with the network
board only).
19) Turn of the power switch.
20) End.
3 - 6
COPYRIGHT © 2002 CANON INC.
S R
N R
N R
N R
N R
N R
+ E
2 3 , - > 1
D N
2001 2001 2001 2001 CANON Printer Board-N1/iN-E5 REV.0 JAN. 2002
E V IC E M E N U
Press the Menu key.
V A M M E N U
Press the Item key.
V A M M E N U
V AM =CHECK
Press the Value key.
V A M M E N U
V A M = D U P L IC A T E
Press the Enter key.
R A L L Y / - I G N O R E
Press the Enter key.
O E
END
F03-103-04